70cc kit installation

General discussion forum for repairing and riding mopeds

Moderators: ItsLookingUp, pehuskey, Tab, mountainmoped, JD, John

70cc kit installation

Postby Jdall1 » Tue Sep 04, 2012 7:36 pm

My 70cc kit has arrived!!! i have installed one before but it has been a while.
again i have a 2008 tomos streetmate r.
does anyone know of a video tutorial to install the kit or instructions of some sort???
Dallas
Jdall1
Net Rider
 
Posts: 4
Joined: Fri Aug 24, 2012 6:02 pm
Location: Connecticut

re: 70cc kit installation

Postby roornwomps25 » Tue Sep 18, 2012 12:36 am

open box. take piston and rings out. gently and carefully place rings on piston making sure they squeeze and close together right where the little knotch is in the ring placement. push piston pin through the hole just a little bit. lubricate everything with 2stroke, even the rings when installing. put circlip on the side you didnt push the pin through using needle nose (do not drop in case!). squeeze rings around piston making sure they are set right to those nubs and gently install into new cylinder. take old setup off. install gasket. slide new cylinder on while holding crank to aline the holes up. tap pin through piston and crank with the roller bearing in the crank (i use a flathead and deadblow hammer). insert 2nd circlip (make sure they are in the slot locked in) and push cylinder down. push head on gasket or no gasket... doesnt matter with tomos. torque head to specs. good to go!
~RVA Rebel Rouser~
roornwomps25
Net Rider
 
Posts: 13
Joined: Fri Jun 08, 2012 2:19 am
Location: Richmond, VA


Return to Moped Riders

Who is online

Users browsing this forum: Bing [Bot], fbarraza28 and 13 guests