Is my oil sensor suppose to do this?

General discussion forum for repairing and riding mopeds

Moderators: ItsLookingUp, pehuskey, Tab, mountainmoped, JD, John

Is my oil sensor suppose to do this?

Postby Kodaman » Wed Feb 05, 2014 10:27 pm

i have an old Yamha QT50 and i was just poking around to see what i needed. and i lifted up on the seat to reveal the gas and oil to no sup rise. then i was looking at the oil sensor about an 1" - 2" straight back. i grabbed the lip of it and lifted and the whole sensor proceeded to come out!! Is it suppose to do this? If not what do i do?
Net Rider
Posts: 4
Joined: Tue Jan 21, 2014 10:08 pm
Location: Arkansas

Re: Is my oil sensor suppose to do this?

Postby Arlie1180 » Sat Jan 31, 2015 10:11 am

Yes only held in by the rubber on the sensor. Should be a little hard to pull out but it's old. It is fine unless it leaks. If it does just don't fill the oil to the brim stop just below the bar in side the oil reserve or you could try something like rtv gasket maker.
Net Rider
Posts: 3
Joined: Sat Jan 31, 2015 9:57 am

Return to Moped Riders

Who is online

Users browsing this forum: Bing [Bot] and 5 guests