Puch maxi axle

General discussion forum for repairing and riding mopeds

Moderators: ItsLookingUp, pehuskey, Tab, mountainmoped, JD, John

Puch maxi axle

Postby ybot1983 » Mon Feb 17, 2014 10:39 am

can someone advise whether there is a a sequence of tightening the axle bolts on a Puch maxi.

I repaired a flat rear tyre and after refitting the wheel it seems to be binding some how although the brakes not attached. should tighten one side before the other?

Toby
ybot1983
Net Rider
 
Posts: 21
Joined: Fri Oct 11, 2013 2:55 am
Location: London

re: Puch maxi axle

Postby mopedlar » Mon Feb 17, 2014 12:48 pm

The tightening sequence shouldn't matter. It sounds like your bearings are binding. Make sure the axle cones are loose enough to keep the bearings from binding. It may be time to disassemble the axle assy, clean and grease everything and then reassemble.
MoPedLar
User avatar
mopedlar
Regional Rider
 
Posts: 511
Joined: Fri Feb 20, 2009 10:25 pm
Location: New Jersey

re: Puch maxi axle

Postby John » Mon Feb 17, 2014 4:11 pm

As Larry says, think of the cups/cones on a bycycle.... similar set up.
John

"Plan your life like you will live forever, and live your life like you will die the next day!"
User avatar
John
Master Regional Rider
 
Posts: 4444
Joined: Tue Nov 18, 2003 9:52 pm
Location: Caledonia, Ontario, Canada


Return to Moped Riders

Who is online

Users browsing this forum: Bing [Bot], Majestic-12 [Bot] and 3 guests